PTZ DRIVER RELEASE NOTES ======================== Release date: 2020-04-21 Release type: Production Firmware version: 4.02 Filename: Ernitec-4.02-mipsisa32r2el-3_46-4_1.ptz --------------------------------------------------------------------- Release 4.02: ============= 4.02:1 This driver will now also work with Ernitec model Orion/3-DN. Known problems and limitations ============================== Note! Some limitations are also device type dependent and can behave different on different Ernitec devices! L01 To use this version of the driver, firmware 5.50 or higher is required. Known problems and limitations with Ernitec "Orion 361 23C" =========================================================== L02 For the model "Orion 361 23C", the address switches should be set to the value of ("Device ID" + 1). L03 When performing a combined pan and tilt movement, the tilt movement will start with a short delay after the pan movement. L04 The same tilt up and tilt down movement will result in a little bit different length of the tilt movement. L05 The iris and autoiris functions are not supported when the model "Orion 361 23C" is selected. It is still possible to manipulate the iris and autoiris functions by using the internal OSD menues inside the PTZ unit. ===========================================================