NEW SOFTWARE RELEASE
                         ====================


 Products involved: AXIS 5600+ (rev 2)
		    
 Release date:      Dec 21, 2004

 Release type:      SERVICE

 Software version:  7.02.0

 File size:         1 426 388 bytes
		   
 Last preceding
 release:           7.00.0
		   

---------------------------------------------------------------------


 Contact Information
 ====================

 Please contact Axis Communications for product information, updates 
 and support at:

 http://www.axis.com


 ---------------------------------------------------------------------


 N.B for ThinWizard users:
 -------------------------

 The preceeding 7.00.0 release is not supported by ThinWizard due to the
 way the DHCP parameter behaves when upgrading from older firmware 
 (see Corrected problems section below).
 
 This document describes the changes made between the 7.00.0 release and this
 release. The release notes for the 7.00.0 release can be found at the 
 following location:

 http://www.axis.com/ftp/pub_soft/prt_srv/5600p_2/7_00_0/7_00_.txt



 Added features in version 7.02.0
 ================================


 Removed functionality
 =====================

 
 Corrected problems in version 7.02.0
 ====================================

 - The DHCP parameter is no longer set to the default value when upgrading
   from a firmware release prior to 6.34 as was the case with the 7.00.0
   firmware.


 Limitations in version 7.02.0
 ================================

 - Support for Checksums in Netware is not implemented.

 - If there is an SLP directory agent on the network and the 
   slp-directory-agent option (RFC 2165) is used by the dhcp server, the Print 
   Servers will most likely end up in a non recoverable endless loop.

 - If the print server receives a NDS tree name via dhcp, and the new name
   differs from the one stored in the print server, then the print server will
   keep on rebooting forever. The solution is either to disable the NDS tree 
   option on the DHCP server, or to configure the print server on a network
   where no DHCP server is present.
         
 - Axis ThinWizard is the recommended management tool to use with this print
   server. HP WebJetadmin is neither tested nor supported with this release.

 - FW 7.02.0 is not fully compatible with TW 3.00.  The Print Server 
   name will be missing and the Status reported by TW 3.0 will be wrong. 
   For full functionality please use TW 3.04, or higher. TW 3.04 is 
   estimated to be released no later than Feb 4 2005.

 - Firmware release 7.00 and onwards only supports print servers with Axis brand name.